Kontron CG1200 Carrier Grade Server - Manual (Page 23)

17
Kontron CG1200 Carrier Grade Server Installation and Maintenance Guide 17
3. Lift the cover straight up to remove it from the chassis (“C”).
Figure 9: Removing the Cover
3.2.2 Re-installing the Chassis Cover
When you are finished working inside the chassis, you must put the cover back on before turning the
server back on. This step is required to ensure proper cooling.
Re-Installing the Cover
1. Starting from the rear of the chassis, place the cover down over the chassis with the side edges
outside the chassis walls.
2. Slide the cover forward until it is flush with the front panel.
3. Tighten the blue thumbscrew at the front of the top cover.
4. Reconnect any external devices and the power cord(s).
CAUTION: This unit must have the cover installed when it is running to ensure proper cooling.
3.2.3 Removing the Front Bezel
You need to remove the front bezel for tasks such as:
•
Installing or removing hard disk drives
•
Observing the individual hard disk drive activity/fault indicators on the drive carriers
•
Replacing the control panel LED/switch board
•
Accessing SD card slot