Kontron CG1200 Carrier Grade Server - Manual (Page 64)

58
Kontron CG1200 Carrier Grade Server Installation and Maintenance Guide 58
Figure 48: Installing the I/O Module
4.9 Installing an eUSB Flash Drive
A separately purchased, optional Embedded USB flash drive (eUSB) provides local USB flash memory
storage for various uses, such as system information, diagnostic partitions, and configuration data. The
eUSB is installed on the front panel board.
Before you can install an eUSB module, you must power down the system and remove the chassis cover.
(You may also have to disconnect some of the cables on the front panel board if they are in the way or
remove the front panel board from the chassis in order to do this installation in such a small crowded
area.)
1. Power down the server and disconnect any external devices and the power cord(s).
2. Remove the chassis cover. For instructions, see Section 3.2.1, “Removing the Chassis Cover”.
3. Remove the front bezel if you will be using the ESD ground attachment with your anti-static wrist
strap. For instructions, see Section 3.2.3, “Removing the Front Bezel”.
4. Locate the standoff and connector on the front panel board, to the right of the SD flash module
(Figure 49).
5. Install the eUSB module onto the front panel board by plugging the USB connector on the eUSB
module onto the USB header on the FPB (“A”) and fastening the module to the metal hex standoff on
the FPB (“B”).
6. If this is the last task you are performing, re-install the front bezel and the chassis cover. Reconnect
all external devices and the power cord(s).