Kontron CG1200 Carrier Grade Server - Manual (Page 58)

52
Kontron CG1200 Carrier Grade Server Installation and Maintenance Guide 52
9. If this is the last task you are performing, re-install the riser card assembly and replace the front bezel
and the chassis cover.
Reconnect all the external devices and plug in the power cord(s).
Figure 42: Installing and Securing the Riser Card Assembly
4.7 Installing a Remote Management Module 4
The Remote Management Module (RMM) solution for the CG1200 server uses RMM4 in the iBMC on the
S2400EP4 server board. There are two options: the Intel® Remote Management Module 4 kit and the
Intel® Remote Management 4 Lite. This procedure shows how to install RMM4 Lite first and then full
RMM4.
The RMM4 kit includes a dedicated NIC module and a small key card to enable full functionality. (It also
contains other hardware and cables that are not used for installation in the CG1200 system.)
To install the RMM4 module you must first remove the chassis cover and the riser card assembly.