Kontron CG1200 Carrier Grade Server User Manual
Page 37
31
Kontron CG1200 Carrier Grade Server Installation and Maintenance Guide 31
Figure 22: Installing a Heat Sink
3.3.7 Configuring Jumpers on the Server Board
The jumpers are located on the S2400EP4 server board. The system comes with the baseboard jumpers
configured in the default position for normal system operation. Only change the jumper position for
performing the desired recovery procedures outlined in this section. To work with the jumpers defined in
this section, you must first power down the chassis, remove the cover, remove riser card assembly as
described in Section 3.2 “General Installation Procedures”, and any optional modules or cables that might
be in the way. The other components on the server board can remain in place.
These 3-pin jumper blocks can be used to configure, protect, or recover specific features of the server
board. This section shows the jumper blocks available and what they do. For detailed information about
using these jumpers, see the Intel® Server Board S2400EP4 Family Technical Product Specification,
Chapter 9, “Reset and Recovery Jumpers”.
Pin 1 on each jumper block is identified by this symbol on the silkscreen:
▼
Figure 23 shows the jumper blocks.