Kontron CG1200 Carrier Grade Server - Manual (Page 63)

57
Kontron CG1200 Carrier Grade Server Installation and Maintenance Guide 57
Figure 47: Adjusting the I/O Module Standoffs
7. Install the I/O module into the rear of the chassis by lining up the three holes on the board with the
three standoffs and the module connector with the connector at the edge of the server board (Figure
48, “A” and “B”).
8. Secure the I/O module to the chassis by fastening the three screws that shipped with module into the
three standoffs. (“C”).
9. If this is the last task you are performing, replace the riser card assembly and the chassis cover.
Reconnect any external devices and plug in the power cord(s).