EVCO EPH4EXP Hardware manual - Manual (Page 55)

EVCO S.p.A. c-pro 3 | Hardware manual ver. 3.2 | Codice 114CP3E324
page 55 of 116
6. CONFIGURATION
6.1. Configuring a programmable controller
6.1.1. Configuring a built-in programmable controller
To gain access to the procedure operate as follows:
1. Make sure the power supply is switched on.
2. Keep pressed 2 s buttons UP and DOWN: the display will show the following menu (hereinafter called Main menu).
<CPro 3 Mega LCD>
Info
English
Parameters
...
Parameter Key
Diagnostic
Debug
It is also possible to configure the controller using an user interface; look at paragraph 6.3 “Configuring a device through en
user interface”.
To gain access to a submenu operate as follows:
3. Press and release button UP or button DOWN to select the submenu.
4. Press and release button ENTER.
The access to the Parameters submenu, to the Networks submenu, to the Password submenu and to the Parameter Key
submenu is protected by password.
To gain access to the Parameters submenu, to the Networks submenu, to the Password submenu and to the Parameter Key submenu
operate as follows:
5. From step 2, press and release button UP or button DOWN to select the submenu.
6. Press and release button ENTER.
7. Press and release button ENTER again to set the password value.
8. Press and release button DOWN over and over again to set “-19”.
9. Press and release button ENTER again.
To modify a parameter operate as follows:
10. From step 9, press and release button UP or button DOWN to select the parameter (some parameters belong to a possible
submenu; press and release button ENTER to gain access to them).
11. Press and release button ENTER.
12. Press and release button UP or button DOWN to modify the value.
13. Press and release button ENTER to confirm the value.
14. Press and release button ESC over and over again to go back to the Main menu.
To modify the language of the application software pages operate as follows:
15. From step 2, press and release button UP or button DOWN to select the voice Language (according to the factory setting it
has value “English”).
16. Press and release button ENTER.
17. Press and release button UP or button DOWN to modify the language.
18. Press and release button ENTER to confirm the value.