EVCO EPH4EXP Hardware manual - Manual (Page 90)

EVCO S.p.A. c-pro 3 | Hardware manual ver. 3.2 | Codice 114CP3E324
page 90 of 116
Diagnostic RTC parameter available in read only modality
non volatile memory status
ok = not in error
err = in error
Diagnostic STACK parameter available in read only modality
clock status
ok = not in error
err = in error
low = loss of data
Diagnostic Power Supply parameter available in read only modality
stack status
ok = not in error
err = in error (because of overflow)
Diagnostic 5V Ratio parameter available in read only modality
power supply voltage status
ok = not in error
err = in error (because of out of
range voltage)
Diagnostic 24V Sensor parameter available in read only modality
status of the power supply voltage of the
ratiometric transducers
ok = not in error
err = in error (because of out of
range voltage)
Diagnostic 24V CAN bus parameter available in read only modality
status of the power supply voltage of the
user interface
ok = not in error
err = in error (because of out of
range voltage)
Diagnostic Math parameter available in read only modality
Math status
ok = not in error
err = in error (because of overflow,
underflow, division by zero or
NaN)
Diagnostic Key Par parameter available in read only modality
result of the copy of the parameters from the
controller to the programming key EVKEY10
and vice versa
ok = operation successful
completed
err = operazione failed
Debug
[ Algo ]
Main time parameter available in read only modality
main cycle time of the application software
(in milliseconds)
Int. time parameter available in read only modality
interrupt cycle time of the application
software (in milliseconds)