EVCO EPH4EXP Hardware manual User Manual
Page 76
EVCO S.p.A.
c-pro 3 | Hardware manual ver. 3.2 | Codice 114CP3E324
page 76 of 116
Diagnostic
Key Par
parameter available in read only modality
result of the copy of the parameters from the
controller to the programming key EVKEY10
and vice versa
ok
= operation
successful
completed
err
= operazione failed
Debug
[ Algo ]
Main time
parameter available in read only modality
main cycle time of the application software
(in milliseconds)
Int. time
parameter available in read only modality
interrupt cycle time of the application
software (in milliseconds)
Debug
[ CAN bus ]
rx
parameter available in read only modality
number of packages in transmission
tx
parameter available in read only modality
number of packages in reception
Debug
[ CAN bus ]
err
parameter available in read only modality
number of packages in error
ovf
parameter available in read only modality
number of packages in overflow
Debug
24VPS
parameter available in read only modality
misura della tensione di alimentazione
5VP
parameter available in read only modality
reading the power supply voltage of the
ratiometric transducers
Debug
24VP
parameter available in read only modality
reading the power supply voltage of the
0-20 mA / 4-20 mA / 0-10 V transducers
24VE
parameter available in read only modality
reading the power supply voltage of the user
interface
Debug
Stack
parameter available in read only modality
minimum free stack
Buf
parameter available in read only modality
number of free buffers
Notes:
(1)
the submenu is visible on condition that the application software expects the first RS-485 port is configured to support the
Modbus communication protocol
(2)
the submenu is visible on condition that the application software expects the second RS-485 port is configured to support the
Modbus communication protocol
(3)
the parameter is meaningful on condition that the second RS-485 port is configured to support the Modbus master
communication protocol
(4)
the parameter is visible only in c-pro 3 NODE mega.