EVCO EPH4EXP Hardware manual User Manual
Page 91
EVCO S.p.A.
c-pro 3 | Hardware manual ver. 3.2 | Codice 114CP3E324
page 91 of 116
Debug
[ CAN bus ]
rx
parameter available in read only modality
number of packages in transmission
tx
parameter available in read only modality
number of packages in reception
Debug
[ CAN bus ]
err
parameter available in read only modality
number of packages in error
ovf
parameter available in read only modality
number of packages in overflow
Debug
24VPS
parameter available in read only modality
misura della tensione di alimentazione
5VP
parameter available in read only modality
reading the power supply voltage of the
ratiometric transducers
Debug
24VP
parameter available in read only modality
reading the power supply voltage of the
0-20 mA / 4-20 mA / 0-10 V transducers
24VE
parameter available in read only modality
reading the power supply voltage of the user
interface
Debug
Stack
parameter available in read only modality
minimum free stack
Buf
parameter available in read only modality
number of free buffers
Notes:
(1)
the submenu is visible on condition that the application software expects the first RS-485 port is configured to support the
Modbus communication protocol
(2)
the submenu is visible on condition that the application software expects the second RS-485 port is configured to support the
Modbus communication protocol
(3)
the parameter is meaningful on condition that the second RS-485 port is configured to support the Modbus master
communication protocol
(4)
the parameter is visible only in the models with second CAN port
(5)
the parameter is visible only in the models with MP-Bus port
(6)
not available in the models with second CAN port.