Interlogix Monitor XL Hardware Guide - Manual (Page 11)

22-0375 rev1.1 Monitor ISM/xL™ Hardware Guide 7
Suite Security LED Keypads
for Apartment and Office Protection
2 Zone
1 2 3
4 5 6
7 8 9
0 #
1 2
Keypad Flip Cover
Protection Point # 1
Red Light
E.g. Main Entrance Door
System Trouble
Yellow Light
System Ready to Arm
Green Light
System Armed Red Light
Flashing = System Fully ON
Solid = System in STAY
Protection Point # 2
Red Light
E.g. Entry/Exit Route
Motion Detector
Wiring
BLUE Output switching to ground.
RED Module Bus (+)12VDC Power
GREEN Module Bus Data A
YELLOW Module Bus Data B
BLACK Module Bus VDC Power (--)
ORANGE Protection Point Input # 1
PURPLE Protection Point Input # 2
BLACK #2 Either black can be used for
a Module negative BUS connection or
input point common connection. E.g. this
black could be used to connect input 1
and 2's common connection. A local
power supply's negative connection can
be connected to either of them as a
common for the output to operate.
"B" Connect Wire Flyleads to system cables.
Mounting Holes
Release Tab. Insert flat head screw driver to push tab forward and release base
from keypad enlcosure to mount base.
(P/N 496-1700)
5 digit serial number to
program in "Suite Security"
Programming. Located on
keypad circuit board back,
when this plastic base is
removed from keypad
housing.
W
ire
Fl
yle
ad
s
Keypad
Base
(back
view)
XXXXX
IMPORTANT: Must refer to Installation Instructions P/N 21-9050 for detailed information.
User Guide P/N 22-9050
IMPORTANT: Refer to
Installation Instructions P/N
21-9050 for Power & Cable
Ratings / Requirements.