Interlogix UltraView IP PTZ 36X Camera User Manual - Manual (Page 11)

Chapter 2: Installation
UltraView IP PTZ 36X Camera User Manual 7
To install the pendant-mount cameras:
1. Prepare the mounting surface and install the camera bracket.
2. Unscrew the bubble from the camera and remove the protective tape from the
PTZ module.
3. Press the two tabs on either side of the PTZ module and remove it from the
camera housing. Ensure the module cables still exit from the cable entry hole
in the top of the housing.
Note: If alarm and audio input/output relays are to be used, connect them to
the PCB of the module and route their cables through the cable entry hole on
top of the housing. See “Connections” on page 11 for further information on
the alarm connections.
4. Attach the camera housing to the bracket using the screws enclosed with the
bracket, as shown below.
5. Insert the PTZ module into the housing.
Position the tabs on the PTZ module by aligning the arrow label on the
module with those on the housing (see below). The module should firmly
snap into position.
Note: If using a SDHC card, insert it into the camera before inserting the PTZ
module into the housing.
6. Re-attach the bubble by screwing it to the housing using three M3 screws.
7. Route the PTZ module cables through the bracket.