Interlogix UltraView IP PTZ 36X Camera User Manual - Manual (Page 66)

Chapter 7: Alarm setup
62 UltraView IP PTZ 36X Camera User Manual
The alarm output delay is the length of time that an alarm output triggers
before stopping. Select a
Delay option: 5, 10, and 30 seconds, 1, 2, 5, and 10
minutes, and Manual stop. If “Manual stop” is selected, the alarm output will
stop only when the alarm input stops.
4. Select an output mode.
This refers to the sensor type. You can select Normal Open (NO) or Normal
Close (NC) according to the sensor type.
5. If required, copy the settings of this alarm output to the other alarm output.
6. Click Save to save changes.
Note: The camera will prompt you to reboot in order for the changes to take
effect.