Interlogix UltraView IP PTZ 36X Camera User Manual - Manual (Page 24)

Chapter 3: Using the Web browser
20 UltraView IP PTZ 36X Camera User Manual
Remote configuration
Use the Remote Configuration panel to remotely configure the camera, network,
camera, alarms, users, transactions and other parameters such as upgrading the
firmware. See Figure 9 and Table 4 below below for descriptions of the different
configuration parameters.
Figure 9: Remote configuration screen
Table 4: Overview of the Remote configuration parameters
Parameter Description
Basic information Defines the device name and RS-485 bus ID as used by the
network. The default name and ID are NetIPDOME and 88.
It also displays the MAC address, device type, device SN,
current firmware version, U-Boot version and current server
time. These values are prepolulated. You can sync the
camera time to the PC time.
See “Camera information” on page 23 for more information.
DST time Defines when daylight saving time starts and ends.
See “DST time” on page 23 for more information.
Channel parameters Defines the OSD properties of camera information, recording
schedule, recording settings for alarm events, alarm response
and overlay text. See Chapter 4 “Camera setup” on page 23
for more information.
Network parameters Defines the network parameters required to access the
camera over the internet. See Chapter 6 “Network setup” on
page 53 for more information.