Interlogix UltraView IP PTZ 36X Camera User Manual - Manual (Page 32)

Chapter 4: Camera setup
28 UltraView IP PTZ 36X Camera User Manual
Parameter Description
Max bit rate Specifiy the maximum allowed bit rate. A high image resolution requires that
a high bit rate must also be selected.
Select one of the options: 32 bps, 48, 64, 80, 96, 128, 160, 192, 224, 256,
320, 384, 448, 512, 640, 768, 896, 1024, 1536, 1792, 2048, or Customize
(enter a value manually). Default is 2048.
Frame rate Specify the frame rate for the selected resolution.
Select one of the options: 1/16, 1/8, 1/4, 1/2, 1, 2, 4, 6, 8, 12, 16, 22, or full
frame (25). Default is full frame (25).
I frame interval A video compression method. It is strongly recommended not to change the
default value displayed, 25.
RTSP port Specify the port used to stream video over an RSTP port.
Naming the camera
This is the camera name that is displayed on screen.
To name the camera:
1. In the Remote Configuration folder, click the Video Setting subfolder to open
its screen.
2. Enter the camera name in the Channel name edit box. The camera name
can have up to 12 alphanumeric characters.
3. Click Save to save changes.
Defining a recording schedule
You can define a recording schedule for the camera in the Schedule Recordings
screen under Camera Parameters. The recording is saved on the SDHC card in
the camera. Although all recordings are saved on the DVR, the camera’s SDHC
card provides a backup in case of network failure, for example. See Figure 12 on
page 29.