Interlogix UltraView IP PTZ 36X Camera User Manual - Manual (Page 14)

Chapter 2: Installation
10 UltraView IP PTZ 36X Camera User Manual
9. Connect the cables (see Figure 1 on page 4).
 Connect the crimp-on BNC connector of the video output to the coaxial
video cable of a monitor (optional).
 Connect the Ethernet cable to a network.
 Connect the power cable to the power source.
Warning: After installation, the PTZ module will perform a PTZ self-test and
initializes with the power on. DO NOT touch and move the camera while it is
self-testing and initializing.
10. Configure the dome camera to suit its location.
Accessing the SDHC card
Insert an 8GB or 16GB SDHC card for local storage as a backup in case the
network fails, for example. The card is not supplied with the camera. See
““Format the SDHC card” on page 66 to format the card.
Video and log files stored on the SDHC card can only be accessed via the Web
browser. You cannot access the card using TruVision Navigator or a recording
device.
Figure 3: SDHC card location
Card slot