Interlogix UltraView IP PTZ 36X Camera User Manual - Manual (Page 61)

UltraView IP PTZ 36X Camera User Manual 57
Chapter 7
Alarm setup
You can define motion detection alarms. A motion detection alarm is an alarm
that is triggered when the camera detects a motion.
Use the Motion Detection screen in the Channel Parameters folder to define the
areas on screen sensitive to motion.
Defining a motion detection alarm requires the following tasks:
1. Events schedule: Define the schedule during which the system inputs and
outputs are operational to detect alarms. See “Event schedule” on page 59.
2. Recording schedule: Define the schedule during which motion detection can
be recorded. See “Defining a recording schedule” on page 28
3. Settings areas: Define the on-screen area that can trigger a motion detection
alarm and the detection sensitivity level. See below.
4. Linkage: Specify the method of response to the alarm. See below.
Motion detection
You can define the area on screen where the motion can be detected, the level
of sensitivity to motion as well as which methods are used to alert you to a
motion detection alarm.
Select the level of sensitivity to motion as well as the target size so that only
objects that could be of interest can trigger a motion recording. For example, the
motion recording is triggered by the movement of a person but not that of a cat.
Note: Deselect the “Enable Motion Detection” option to disable the motion
detection alarm.