Interlogix UltraView IP PTZ 36X Camera User Manual - Manual (Page 53)

Chapter 5: Motion setup
UltraView IP PTZ 36X Camera User Manual 49
When creating your masks, it is a common practice to make them 50% larger
than the areas you wish to cover so that the masked areas remain concealed at
all times. Masks cannot be created in the area directly below the dome camera.
The dome camera takes the center of the selected view as the starting point
when setting a mask.
Figure 22: Mask information
Area to be
masked Privacy mask
0° (+90°) 180° (-90°)
Positive (+)
hemisphere
Negative (-)
hemisphere
Mask 50% larger than the area
to be covered
No window mask is allowed 20° either side of
the 90° (0°) tilt
To define privacy masking:
1. In the Motion folder, click the Privacy Mask subfolder to open its screen.
2. Check the Enable Video Masks box.
Note: To deactivate privacy masking, deselect the Enable Video Mask
option on the Video Mask screen.
3. In the Privacy Mask SN box, select the mask number to be drawn. Place the
mouse pointer at a point on the screen from where you want to start marking
the privacy mask area. Drag the mouse pointer to mark the area to be hidden.
Several areas can be defined.
Note: You cannot adjust an area already drawn. Click Clear All to delete all
drawn areas and redraw.
4. Click Save to save changes.
Time task
Use this menu to define the schedule of tasks such as auto scans, presets,
preset tours, panorama scans and shadow tours.