Interlogix UltraView IP PTZ 36X Camera User Manual - Manual (Page 28)

Chapter 4: Camera setup
24 UltraView IP PTZ 36X Camera User Manual
If the option is enabled, enter the month, day and time when DST starts and ends
and then click
Save .
Camera configuration
This section describes how to configure the camera settings from the Channel
Parameters screen. There are eight subfolders, which are described below:
• Display settings: Defines how the name and date/time are displayed on
screen. By default the name appears in the lower right corner of the screen
and the date/time on the top. See “Display information” on page 25 for more
information.
• Video settings: Defines how the camera records an event. The stream
mode, stream type, resolution, image quality, bit rate, frame rate, and video
compression can all be modified. See “Video recording parameters” on page
26 for more information.
• Schedule recording: Defines the schedule when the camera records.
“Defining a recording schedule” on page 28.
• Motion detection: Defines the on-screen area to trigger a response, the
detection schedule and method of response. See “Motion Detection” on page
37.
• Video tampering: Defines the on-screen area to trigger a response, the
detection schedule and method of response. See “Camera tamper alarm” on
page 30.
• Text overlay: Defines up to four lines of extra text on screen. They can be
positioned anywhere. See “Adding extra text on-screen” on page 32.
• Camera settings: Defines the camera image quality and behavior
parameters such as shutter speed, iris mode, day/night mode, image flip, and
white balance. See “Camera image settings” on page 33.
• Reset image: Resets the camera settings to the previously configured and
saved values. See “Reset ” on page 36.
• Restore image: Restores the camera settings to factory default. See
“Restore ” on page 36.
All changes made apply only to the camera being configured. Parameters cannot
be copied to another camera.
Note: When schedule parameters are modified, the camera will prompt you to
reboot after the changes are saved.