Interlogix UltraView IP PTZ 36X Camera User Manual - Manual (Page 67)

Chapter 87BChapter 8: Camera management
UltraView IP PTZ 36X Camera User Manual 63
Chapter 8
Camera management
This chapter describes how to use the camera once it is installed and configured.
User management
This section describes how to manage users from the User Management screen.
You can:
 Add or delete users who can access and control the camera
 Modify passwords
 Assign access privileges to users
Only the administrator can manage users. The administrator can create up to 15
additional individual users and allocate privileges to each of them. When new
users are added to the list, the administrator can define individual passwords or
each user can use a default password. See Figure 28 on page 64.
Passwords limit access to the camera and the same password can be used by
several users. When creating a new user, you must give the user a password.
There is no default password provided for all users. Users can modify their
password. However, only an administrator can create a password for a user.
Admin passwords can have up to four digits, ranging from 1 to 4, to allow you
access to the camera.
Note: Keep the admin password in a safe place. If you should forget it, contact
technical support.
You can control who can connect to a camera by the user IP and physical (MAC)
addresses entered for a user. Setting up a user with a MAC address from the
user’s computer prohibits access to the camera from other computers. All users
can connect to a camera when IP and MAC addresses are set to zero.
The user access rights must be set up for each camera individually.