Interlogix UltraView IP PTZ 36X Camera User Manual - Manual (Page 33)

Chapter 4: Camera setup
UltraView IP PTZ 36X Camera User Manual 29
Figure 12: Schedule recording screen
The selected recording schedule applies to all alarm types.
You will be prompted to reboot the camera after making any schedule
modifications.
Pre and post-event recording times
The pre-event record time is used if you have the motion detection and/or
external alarms enabled. Pre-event time refers to the time recorded before a
motion or external alarm is triggered and includes the alarm data. If a motion or
external alarm occurs and you have set the pre-event time to 5 seconds, the
camera will record and save up to 5 seconds prior to the alarm event. Pre-event
time options include: No Pre record, 5 (default), 10, 15, 20, 25, and 30 seconds.
The post-event record time is used if you have the motion detection and/or
external alarms enabled. When an external or motion alarm is cleared, the
camera will continue recording based on the value specified in this option.
Options include: 5 (default), 10, 30 seconds, 1, 2, 5, and 10 minutes.
To define a recording schedule:
1. In the Channel Parameters folder, click the Schedule Recordings subfolder
to open its screen.
2. Click the Enable Recording box to enable recording.
Note: Deselect the option to disable recording.
3. Select the pre and post event record times.
4. Select the recording period: All day recording or Section recording .