Interlogix UltraView IP PTZ 36X Camera User Manual - Manual (Page 46)

Chapter 5: Motion setup
42 UltraView IP PTZ 36X Camera User Manual
Figure 18: PTZ limited screen
Table 7: PTZ Limited menu
Parameter Description
Enable limit Check to enable limitations on the PTZ function.
The option is unchecked by default.
Limit type Defines whether the movement limitations apply only when the
image is being manually controlled (Manual stops) or when
movement a scan function (Scan stops).
Type status Shows whether the PTZ movement is currently restricted or
unrestricted.
Start Starts the movement limitation configuration.
OK Ends the movement limitation configuration.
Clear Deletes the defined movement limitation.
To set a limit on PTZ movement:
1. In the Motion folder, click the PTZ Limited subfolder to open its screen.
2. Click Enable Limit to enable movement limitation set up.
3. Click Start to start the movement limitation set up. Text appears on the
screen with instructions on defining the movement limitation to the left.