LAARS NeoTherm NTV1000 - Install and Operating Manual - Manual (Page 47)

NeoTherm Boilers and Water Heaters Page 43
8.9 Cleaning the touchscreen
The operator interface includes a cleaning routine
for the touchscreen. If the screen was active while
you cleaned it, you might enter a series of random
commands or parameters. During the cleaning
routine, the screen is disabled so it will ignore any
commands you might send.
1. From the Home Page, press the Setup button.
Figure 47 shows the Display Setup screen.
fig. 47 - Display Setup Screen
2. Press the Clean Screen button. The
screen which follows will list the cleaning
instructions.
fig. 48 - Clean Screen Instructions
Once you press Continue, the screen will be
disabled for 20 seconds. A timer will count
down the remaining time.