LABEC M-MIA-LA - Manual (Page 33)

Ultrasonic milkanalyser
Operation manual 04.11.09 31/107
6.3.2.1. Press the button Enter and without releasing it switch on the power
supply of the device, wait for the starting identification messages and release
the button after the following message appears on the display:
Release button
to start setup
After releasing the button on the display is shown:
MA Setup
followed by possible to be entered by the operator menus:
Special modes
Corrections
Settings
------------------------------
Tests
pH & Co Meter
Accessories
Exit
6.3.2.2. By using buttons “up” ▲ and “down” ▼position on Corrections and
press Enter.
6.3.3. Making correction
6.3.3.1 Determining the correction mode
When starting Corrections, the following appears on the display
Corrections:
Calibration 1
Calibration 2
Calibration 3
---------------------------
Temperature
Exit