LABEC M-MIA-LA - Manual (Page 43)

Ultrasonic milkanalyser
Operation manual 04.11.09 41/107
7.2.3. Settings.
Serve for assigning different working parameters (modes).
7.2.3.1. Net number.
Serves for assigning the device network number when connecting it in the
production network. The possible numbers are from 0 to 15 including.
After starting this function the display shows the following:
Net number
0
- OK +
By using the button “up”▲ the operator has the possibility to increase the
number, showing the channel’s number, and by button “down”▼, to decrease
it. Pressing the button Enter saves the chosen channel and exits the function.
When connected in the production network each device has to have a
unique number.
7.2.3.2. COM1 mode.
Serves for choosing the working mode of COM1 (RS232 on the rear panel).
Chooses the device towards which the measurement results are send. There
are two possibilities:
- towards a personal computer - PC;
- towards serial printer - Prn.
After staring this function the display shows the following:
COM1 mode:
Prn _
PC OK Prn
Using the button “up”▲” the operator has the possibility to send the results
towards Prn, and by button “down”▼, towards PC. Pressing the button Enter
saves the chosen output device and exits the function.
Forwarding the printer towards COM1 is necessary when connecting
additional external keypad to the analyser. In this case the keypad is
connected to connector Printer, and the printer – to connector RS 232.