Changing presser feet snap-on presser feet, To remove and replace foot, Changing the needle – SINGER 8614 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
la
1b
CHANGING PRESSER FEET
Snap-on Presser Feet
The presser feet furnished with your machine
snap on and off a common shank.
Raise needle to highest position by turning the
hand wheel toward you. Raise presser foot.
To Remove and Replace Foot
1 a. Press toe of presser foot upward as far as
it will go.
1 b. Then snap down to remove.
2. Centre the new presser foot under the
shank A and lower the presser foot lifter so
that the shank fits the presser foot pin.
3. Press presser foot screw down firmly until
foot snaps into place.
CHANGING THE NEEDLE
• Raise needle to its highest point by turning
the hand wheel toward you. Loosen needle
clamp screw B and remove the needle.
• Insert new needle up into clamp C as far as
it will go. with the flat side of the needle to
the back.
•
• Tighten needle clamp screw.