Removing and replacing needle plate, Attaching snap-in feed cover, Attaching blindstitch hem guide – SINGER 8614 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
REMOVING AND REPLACING
NEEDLE PLATE
• Raise presser foot
• Raise needle to highest position.
• Open slide plate. Place thumb under right
side of needle plate, lift it up and withdraw it
to right.
• Replace needle plate under clamping pin A,
push it gently to the left and press down
until it snaps into place.
ATTACHING SNAP-IN FEED COVER
• Raise presser foot.
• Raise needle to highest position by turning
hand wheel toward you. Open slide plate.
• Slide snap-in feed cover away from you
over needle plate until points B and C are
positioned directly over holes in needle pla
te as illustrated. Snap in point B. Then push
point C in toward point B until it snaps into
place. Close slide plate. To remove, open
slide plate then simply lift up front edge of
feed cover.
ATTACHING BLINDSTITCH
HEM GUIDE
• Raise presser foot, loosen presser foot
screw with a coin and slip blindstitch hem
guide between screw and shank of the
general purpose foot.
• Be sure underside of the guide clears the
slide plate and front of foot.
•
• Tighten screw with a coin.
11