Buttons, Attaching a button – SINGER 8614 User Manual
Page 65
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
I
I
I
I
0
Buttons
y_________________
I
I
I
I
0
iniiiii!
• Pattern Selector: 1-2-3-4
• Needle Position: lt)y3ci
• Stitch Width: To suit button
• Stitch Length: 0
• Snap-in Feed Cover
• General Purpose Foot
ATTACHING A BUTTON
Flat buttons can be sewn on by machine
using the zig-zag stitch.
• Insert Snap-in Feed Cover as instructed
on page 11.
1. Set stitch width selector at 0.
• Set needle position at left «L .
• Place button positioned on fabric under
foot and lower needle into centre of left
hole.
• Lower presser foot.
• Turn hand wheel toward you until the
needle rises out of button hole and is
just above the presser foot.
2. Set stitch width selector to a medium width
zig-zag setting.
• Continue turning hand wheel until the
needle Is above right hole, adjust stitch
width, as necessary, until needle enters
the centre of the right hole.
• Take six or more zig-zag stitches and fin
ish with the needle on the left.
3. Move stitch width selector to 0 and take a
few stitches to fasten threads.
• Pull thread ends through to back of
garment knot close to fabric and snip off
loose ends of thread.
63