Threading the machine, Threading the bobbin case – SINGER 8614 User Manual
Page 23
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Threading the machine
• Raise the presser foot to release tension discs
and make sure needle and take-up lever are in
highest position.
• Place spool of thread on horizontal spool pin.
• If spool being used has a thread retaining slit B,
it should be placed against the spool cushion to
the right.
• Select correct spool cap for type and diameter
of spool being used.
• The cap should be larger than the spool itself.
• Slide spool cap against spool.
• Snap thread into “snap-in thread guide” 1.
• Snap thread into upper thread guide 2.
• Pass thread through point 3.
• Thread the needle thread tension 4
.
Slide thread
over metal plate into tension discs. Lead thread
under needle thread tension and through tension
wire by firmly pulling thread straight up.
• Pull thread to right behind point 3 guiding thread
up toward take-up lever.
• Pass thread through points 5 to 7 as shown.
• Thread needle from front to back and draw
about 10 cm (4 inches) of thread through eye of
needle.
21