SINGER 1411 User Manual

Page 69

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

1.

Put button in carrier

a

and slide clamp

b

back with thumb of left hand. Length

of buttonhole is set by button carrier
clamp on foot.

2.

Pull down buttonhole lever as far as it

will go.

Placez le bouton dans le support

a

à

l’arrière du pied et ramenez le curseur

b

contre le bouton. La longueur de la
boutonnière est réglée par la position
du curseur.

2. Abaissez au maximum le levier bouton­

nière.

1.

Ponga el botón en el portabotón

a

y

deslice el mecanismo de sujeción de
nuevo en su puesto con el pulgar de la
mano izquierda. La longitud del ojal se
ajusta mediante el mecanismo de sujeción
en el pie.

2. Baje la palanca del ojal tan lejos como

pueda.

• Raise presser foot lifter.

• Soulevez le releveur du pied presseur.

Suba el elevador del prénsatelas.

3. Hold upper thread lightly with left hand

and turn hand wheel slowly

toward you

until needle enters the plate.

Be careful

that you do not run the machine during
this procedure.

Continue turning hand

wheel and holding upper thread until

needle rises. Tighten yourhold on upper

thread and bring up lower thread in a

loop. Release upper thread.

Slide scissors between foot

c

and un­

derplate

d

and draw both upper and

lower threads diagonally toward the
back of the foot, leaving approximately

10 cm (4 inches) of thread.

3.

Tenez légèrement de la main gauche

le fil supérieur et tournez doucement

vers vous le volant jusqu’à pénétration
de l’aiguille dans la plaque â aiguille.

FAITES ATTENTION A NE PAS FAIRE
FONCTIONNER LA MACHINE DURANT
CETTE OPERATION. Continuez à tourner
le volant, sans lâcher le fil, jusqu’à ce
que l’aiguille remonte en position haute.

Tirez le fil supérieur pour faire remonter

le fil inférieur.

Glissez des ciseaux entre le pied

c

et la

plaque

d,

tirez les deux fils environ 10 cm

en diagonale vers l’arrière du pied.

3. Levante el elevador del prénsatelas. Sujete

el hilo superior ligeramente con la mano
izquierda y gire el volante lentamente

hacia usted

hasta que la aguja penetre en

la plancha.

Tenga cuidado de que la

máquina no se ponga en marcha durante

este proceso.

Continúe girando el volante

y sujetando el hilo superior hasta que la
aguja suba. Apriete su sujeción en el hilo
superior y traiga el hilo Inferior en un

bucle. Suelte el hilo superior.

Deslice unas tijeras

entre el prénsatelas C

y la plancha D

y traiga los dos hilos, el

superior y el inferior en diagonal hacia la
parte posterior del prénsatelas, dejando
aproximadamente 10 cm. de hilo.

67

Advertising