Bonaire Comfort Control - RF/LV - Manual (Page 17)

Multi-Appliance Comfort Control
Ducted Gas Heating
• When the temperature has gone past the set temperature by
approximately a ½º the central heater will shut down.
• When the temperature has dropped approximately 1º below
set temperature the unit will restart.
• As your activities vary, you may find you need different
temperature settings, e.g. a temperature comfortable for
sitting is usually too warm compared to when you’re moving
about.
• For economical operation, set a low SET TEMP during the
day when you are active, or use ECONOMY. Switch the
Comfort Control OFF when asleep and ON again when
awake. These cost saving functions can be programmed to
operate automatically (see Programmed Control).
8. Press the ON/OFF button to switch the heater OFF. OFF will
appear on the display.
9. The Comfort Control remembers your SET TEMP setting and
uses it next time you turn it ON.
ECONOMY & BOOST
FOR HEATING
ECONOMY operates the heater at the lowest fan speed and a lowest
possible gas rate continuously.
Note: - Continual use of economy may not heat the environment
effectively.
BOOST operates at the highest fan speed and a highest possible gas
rate continuously.
1. To select ECONOMY or BOOST switch the Controller ON and
select HEAT and MANUAL.
2. Now press ECONOMY/BOOST. The display will first show
ECONOMY. Press again and BOOST is shown. Save your
selection by pressing ENTER.
3. Set Temperature to the desired level.
S UMMER F AN
With Gas Ducted Central Heating the control default is to run a Dual
Cycle Add-on Cooling system if installed. If there is no Add-on Cooling
you can use the fan only to circulate the air. To operate:
1. Press ON/OFF to switch the controller ON.
2. Press the HEAT/COOL/FRESH AIR button until COOL appears
by it’s self in the mode selection line of the LCD.
The room air fan will now run.
Comfort Control - PNE Page 17