Bonaire Comfort Control - RF/LV - Manual (Page 20)

Multi-Appliance Comfort Control
Ducted Gas Heating
5. Setting the time to start the program: Using the V W arrows set
the HOUR required and press ENTER. The MINUTES number will
flash. Using the V W arrows set the minutes number required.
The time will now be set. Press ENTER to proceed.
6. Setting the operation parameters: Before accepting or adjusting
the temperature you can also set:-
• ZONE Requirements - If ZONE motors fitted select the zones
to be open or closed.
Press and release the CLEAN FILTER/ZONE ABCD
button. ZONE A (or the current open zone) will flash −
−
−
Press ▼ or ▲ to go to the next zone. Press the
ON/OFF button to set a zone as open (ON) or closed
(OFF). Repeat to open or close more zones.
Press and release ENTER to save your selections.
Now the Heater operates only in your selected zone.
• ECONOMY / BOOST - press ECONOMY/BOOST. The
display will first show ECONOMY. Press again and BOOST
is shown.
7. Setting the Temperature: use the V W arrows set the required
temperature. Press ENTER. The next PROGRAM period will
flash.
8. If next program is required to be OFF use function steps 3 & 5.
The next PROGRAM will now be flashing.
9. If next program is required to be ON. Use steps 3, 4, 5, 6 & 7.
After steps 3, 4, 5, 6 & 7 are completed the next PROGRAM
period will be flashing.
If you want to make corrections to what you've entered, press SET
TIME/PROGRAM twice and you'll start the programming sequence
again. Scroll through the program selections by pressing the ENTER
key and change any items as you come to them.
If at any stage in programming mode you want to revert to the factory
default settings, remove the batteries (RF model only) or turn the power
off to the unit for hardwired controls and the settings will be as they
were before you started.
Comfort Control - PNE Page 20