Bonaire Comfort Control - RF/LV - Manual (Page 33)

Multi-Appliance Comfort Control
Ducted Evaporative Air Conditioning
PRECOOL ON/OFF
The PRECOOL option pre-wets the Fresh Air Conditioner filter pads
before any air is circulated through your home. PRECOOL will flash on
the display.
If PRECOOL is enabled, the unit will run the pump with no fan for 3
minutes every time the air conditioner is turned ON in COOL FRESH
AIR mode.
Setting PRECOOL
• The Controller can be ON or OFF to set PRECOOL.
• Press the MANUAL/AUTO and ECONOMY/BOOST buttons at
the same time.
• PRECOOL ON or OFF will flash. Use the ▼ or ▲ buttons to
select PRECOOL ON or OFF.
• The words will flash for 15 seconds and then the signal will be
sent to your Conditioner. Pressing ENTER will send the signal
immediately.
• The PRECOOL option can be disabled at any time by pressing
MANUAL/AUTO and ECONOMY/BOOST together then
selecting PRECOOL OFF.
F
ILTER
C
LEANING
CLEAN FILTER function operates the pump only for 30 minutes allowing
a nominal wash down of the filter pads. This can help extend the life of
the pads. To activate CLEAN FILTER
1. Press CLEAN FILTER. The unit will perform a self cleaning
procedure which will last for around half an hour. CLEAN FILTER
will flash on the display during this operation.
2. You can exit the CLEAN FILTER procedure at any time by
selecting any of the Fresh Air Conditioning options.
NOTE: Normally during the first 10 days of operation a slight odor will be
present from the CELDEK filter pads. This 'new smell' is quite normal,
and will quickly disappear as your unit is operated.
Comfort Control - PNE
Page 33