Bonaire Comfort Control - RF/LV - Manual (Page 47)

Multi-Appliance Comfort Control
Warranty – Australia ONLY
WARRANTY
IMPORTANT:
Please read this warranty information and complete the Dealer/Product information on the
following page. KEEP this with your original purchase documents for any claim under warranty.
Firstly refer to your owners manual to ensure you have followed the correct operating
procedures of your product, and refer to the trouble shooting guide to assist solving any
problems you may have.
1. Read this warranty statement carefully before you request warranty service as items
relation to installation are not covered by this appliance warranty.
2. A proof of product purchase must be provided for warranty service, to validate the
appliance is within the manufacturer’s warranty periods.
3. This warranty is only for products and associated original controls for Climate
Technologies manufactured product.
4. Only an authorised Climate Technologies service provider must carry out warranty
service.
Climate Technologies provides the following Manufacturers warranty additional to all implied
warranties and other statutory rights which you may have under the Trade Practices Act and
similar State & Territory Laws, subject to the following terms and conditions.
Conditions to warranty
• Subject to the exclusions noted, Climate Technologies warrant the product for the period
as prescribed in the table following this statement to be free from Inherent defects in
materials and workmanship for functional and structural components.
• This product is only valid if the product is operated in accordance with the manufacturers
instructions
• The appliance must not be modified or changed in any way.
• Your proof of purchase MUST be produced before free service will be provided.
• Traveling time and mileage are included within 30km of either your authorised Climate
Technologies dealer or service provider’s premises. Customers in areas other than the
above are responsible for any traveling time and mileage required to carry out warranty
repairs.
• The product must be installed by a qualified person in the manner prescribed by local &
statutory regulations and to the manufacturer’s specifications.
• Service within the terms of this warranty will be recognised where we are satisfied that the
appliance or part was supplied within the relevant time limits. Documents of purchase
and Dealer/Installer information will assist in this process.
• Product fitness for purpose and overall system design / sizing is solely the responsibility
of the dealer / installer. This includes but is not limited to heat load calculations, air flow,
system balancing, humidity, water quality etc.
• The product must be installed in an easily and safe accessible area for service,
appliances installed in areas not easily and safely assessable, costs will be borne by the
owner for access equipment should maintenance be required.
DIY installation Warranty
• If the product has been installed as a DIY, a supply part only warranty will apply. Parts
only will be supplied free of charge on the return of the faulty part and the owner will be
responsible for all labour charges incurred for the part to be fitted by a qualified person.
Labour warranty as prescribed in the following table is void in this situation.
Remote Location Warranty
• If the product has been installed outside the Climate Technologies service network, a
supply part only warranty will apply. Parts only will be supplied free of charge on the
return of the faulty part and the owner will be responsible for all labour charges incurred
for the part to be fitted by a qualified person. Labour warranty as prescribed in the
following table is void in this situation.
Comfort Control - PNE
Page 47