Bonaire Comfort Control - RF/LV - Manual (Page 24)

Multi-Appliance Comfort Control
Dual Cycle Addon Refrigerated Air Conditioning
GENERAL INFORMATION.
I
MPORTANT N OTICE .
If an appropriately qualified and licensed person is not used to install the equipment or if it's not installed
according to the guidelines, then Climate Technologies will not accept responsibility for any problems,
which occur as a result.
D
ATA
L
OCATION
.
Your appliance model number, serial number and model description are located on the appliance data
plate on the access panel. These details should also be in the warranty section of this booklet.
You will need this information, should your appliance require servicing, spare parts or just if you require
additional information about this product.
A SSEMBLY .
There is no assembly required of this Add-on Refrigerated Air Conditioner. Your Dealer or installer will
carry out all assembly and commissioning upon installation
SAFETY
S
AFETY & O WNER R ESPONSIBILITY
The manufacturer and its service providers reserve the right to refuse service unless safety and
accessibility to the unit can be guaranteed. The cost of any extra equipment required to provide access to
the unit for servicing is the responsibility of the owner.
P
RECAUTIONS
.
DO NOT PLACE ARTICLES ON OR AGAINST THE CONDENSER.
DO NOT PLACE ARTICLES IN FRONT OF THE CONDENSER.
ENSURE THE CLEARANCES BETWEEN THE UNIT AND WALL ARE KEPT CLEAR.
DO NOT PLACE ARTICLES IN FRONT OF OR OVER THE RETURN AIR GRILLE.
F
EATURES
.
Your Ducted Gas Central Heater and Add-on Refrigerated air conditioner has all the safety devices to
ensure safe operation. These devices conform to the standards set out by Standards Australia.
P OWER INTERRUPTION .
Should there be an interruption to the power supply during the cooling operation the controls will
automatically shut down.
Your gas ducted heater and or add-on cooler will automatically resume operation once the power has been
restored.
Comfort Control - PNE Page 24