Bonaire Comfort Control - RF/LV - Manual (Page 19)

Multi-Appliance Comfort Control
Ducted Gas Heating
A
UTO
M
ODE
Auto mode is where the Comfort control operates your unit to
a specific set of program settings. The default sequence is as
per the chart. To set your program, see next section
Programming Your Comfort Control.
To operate your unit in AUTO mode, press the
MANUAL/AUTO for the screen to display the word AUTO.
The unit will now turn on and off at specific times and will
change operational functions as programmed.
P ROGRAMMING Y OUR C OMFORT C ONTROL
Programming your Comfort Control will provide energy and time
savings. Your heating and or cooling system will only operate when you
need it, and at your chosen comfort levels.
Determine your most comfortable settings, program them and let your
Comfort Control do the rest automatically.
Programming Sequence
Heater / Dual Cycle Add-on Refrigerated Air Conditioning
If you've never programmed your Comfort Controller before (or it’s been
a while) remember it's easiest to program the whole week to the same
settings (by selecting the whole week MON TUE WED THU FRI SAT
SUN day choice) and then program variations for particular days or the
weekend as you become more familiar with programming.
If the Controller exits program mode it may be because you've paused
longer than about 15 seconds to make your next choice. All the settings
you've made up to then will be saved. Just switch back to program
mode, scroll through your settings using the ENTER key and carry on
from where you left off.
The following is the programming sequence once the control is turned
on:-
1. To Start Program: Press the SET TIME/PROGRAM button.
PROGRAM 1 and the current day will flash.
2. Selecting the Days / Day Group: Press the V W arrows to select
the day or day group to be modified. Options are: Single Day,
MON TUE WED THU FRI or SAT SUN or MON TUE WED THU
FRI SAT SUN. Press ENTER to complete the selection
3. Turning the unit On or Off: Press the ON/OFF button to turn the
unit ON or OFF. At this point the control display will be ON or OFF
and the timer hour number will be flashing.
4. Selecting the Product: if unit ON: If your heater has been fitted
with an add-on refrigerated air conditioner your can now select
between heating and cooling. Press the HEAT/COOL/FRESH AIR
button to select the product require, else proceed to the next step.
Comfort Control - PNE Page 19