Bonaire Comfort Control - RF/LV - Manual (Page 48)

Multi-Appliance Comfort Control
Warranty – Australia ONLY
Exclusions to warranty.
• Consumable items subject to wear and tear such as filter pads, drive belts and bearings
are not covered by this warranty.
• Components used as part of the installation such as grilles fiilters, ducting, fittings, zone
motors and consumer services pipe work are warranted from your place of purchase and
not covered by this warranty.
• Damage caused by elements such as wind, rain, lighting, floods etc along with power
spiking and brownouts are not considered defective material or workmanship and as such
are not considered warranty.
• No responsibility will be accepted for outside elements such as pests, animals, pets and
vermin that may cause damage to the unit.
• Harsh environmental situations such as salt air that may cause cabinet damage / rusting
can not be considered warranty.
• The manufacturer does not accept liability or any claims for damage to building contents,
carpet, walls, ceilings, foundations or any other consequential loss either direct or indirect.
Damage resulting from, power spikes, incorrect operation, incorrect installation, incorrect
maintenance is also not covered.
• All warranties are NOT transferable.
Conditions where warranty may be void.
• If there is no certificate of compliance for plumbing, electrical or refrigeration as required
by State & Territory Laws. Climate Technologies reserves the right to refuse service on
non-compliant installations.
• The defective operation of the appliance that is due to failure of electricity, gas, water or
refrigerant gas supplied.
• Defects are caused by neglect, incorrect application, abuse or by accidental damage of
the appliance.
• An unauthorised person has attempting to repair the appliance.
• A situation arises referenced in the trouble-shooting guide.
• A charge will be made for work done or a service call where there is nothing wrong with
the appliance.
A
GED
N
EW
P
RODUCT
W
ARRANTIES
For a New Product warranty to apply, a product needs to be sold and installed within 3 years of
the manufacturing date.
Product that is aged as the result of extended storage or being used for demonstration purposes,
the following warranty will apply.
• For a product that is greater than 3 years and less than 5 years old from date of
manufacture the statutory warranty will apply and any voluntary warranty originally
supplied will be reduced by 1 year
• For a product that is greater than 5 years of age from date of manufacture, the statutory
warranty will apply to electrically functioning components only. All other components
being cabinets, louvres, filters etc. will not be covered by warranty.
Comfort Control - PNE
Page 48