Bonaire Comfort Control - RF/LV - Manual (Page 18)

Multi-Appliance Comfort Control
Ducted Gas Heating
ZONES - S
ELECTING
ABCD
OPTIONS
Selecting ZONE ABCD only applies if your home is fitted with optional
motorised ductwork dampers (please consult your installer) that allow
opening or closing of each section of ducting.
Many homes have no motorised ductwork dampers fitted, however the
control will still display the ‘A’ zone. Where zone motors are fitted the
installer can set your controller to show only the zones available for
use.
In homes with more than one zone, at least one zone must be open at
all times. The default zone is A if no other is selected.
The Controller will not allow you to turn all off. If you press and release
ENTER with all zones set to off the Controller will recall your last correct
zone setting.
To set the open or closed status of a ZONE:
1. Press and release the CLEAN FILTER/ZONE ABCD button.
ZONE A (or the current open zone) will flash.
2. Press ▼ or ▲ to select the zone you wish to control.
3. Press the ON/OFF button to set a zone as open (ON) or closed
(OFF). Repeat to open or close more zones. If the letter is
already displayed on the LCD screen the zone is open / on.
4. Press and release ENTER to save your selections. Now the
Heater operates only in your selected zone.
O PTIONAL S UMMER S HUTDOWN
1. Switch the Comfort Control OFF
2. Switch the power point OFF and turn the gas tap OFF. They are
usually located close to the Heater.
F
IRST
S
TARTUP OR
R
ESTART
A
FTER
S
HUTDOWN
1. Switch the Comfort Control ON, (Check the batteries are still good
– RF remote model only. It's a good idea to replace them at the
beginning of the season.)
2. Switch on the power point to the heater. Turn on the gas tap on
the gas supply line into the heater.
3. Select HEAT and MANUAL. Press & hold ▼ or ▲ button to
decrease or increase the SET TEMP. Press ENTER.
Comfort Control - PNE Page 18