Bonaire Comfort Control - RF/LV - Manual (Page 22)

Multi-Appliance Comfort Control
Ducted Gas Heating
PROBLEM SOLVING.
C ENTRAL H EATER WILL NOT OPERATE !
Question Y/N Solution
Yes Refer to question 4
1.
Has the unit been run
since installation?
No Check the unit is turned on at the power point and the gas cock is
turned on. Call the installer to commission the unit.
Yes Refer to question 3
2.
Is the unit installed in a
new home?
No Refer to question 4
Yes Refer to question 4
3.
Has the installer run the
unit?
No Check the unit is turned on at the power point and the gas cock is
turned on. Call the installer to commission the unit.
Yes Press the reset buttons or turn the unit off then on to reset unit. If
the unit still does not start call for service. (refer to solution 6 for
reset instructions)
4.
Is the set temperature
greater that the room
temperature?
No Increase the set temperature so the thermostat calls for heat.
Yes The heater may be programmed to be OFF. To operate the heater
manually press the Manual / Auto button until the MANUAL is
displayed. Adjust the room thermostat greater than set
temperature.
5.
Is the thermostat in
program mode?
No Adjust the room thermostat greater than set temperature.
Yes Reset the unit. This can be done by:
1. Turn the power OFF then ON at the power point
2. Turn the control to OFF
3. Pressing the reset button on the circuit control board
6.
Has there been a known
power surge?
No Unit should operate normally. If not a service call will be required.
THIS TROUBLE SHOOTING GUIDE IS A REFERENCE ONLY.
FOR SERVICE OR WARRANTY REQUIREMENTS PLEASE REFER TO
THE WARRANTY SECTION OF THIS BOOK
Comfort Control - PNE Page 22