Bonaire Comfort Control - RF/LV - Manual (Page 5)

Multi-Appliance Comfort Control
Introduction
Your Comfort Controller is designed to automatically detect the appliances during the commissioning of the
unit by the installer. Controller options not required for your appliances will usually not be visible on your
Comfort Control display.
Whether hand held or wall mounted take advantage of the versatility your Comfort Controller offers.
Use your Comfort Controller to reduce your energy bills by selectively conditioning part or your entire home
at an economical reduced rate or by setting programs to suit your needs.
Your Comfort Control is designed in Australia to suit Australian conditions and will ensure that your home
is comfortable all year round.
GENERAL INFORMATION.
I
MPORTANT
I
NSTALLATION
N
OTICE
.
A licensed person is required to install Climate Technologies equipment. If the equipment is not installed in
accordance with the installation instructions and the governing body regulations, Climate Technologies
reserves the right to refuse service on non compliant installations.
Subject to state regulations and by laws a certificate of compliance must be issued for the electrical and
plumbing connections certifying that the work complies with all the relevant standards.
Note: Only a licensed person will have insurance protecting their workmanship.
D
ATA
L
OCATION
.
Your appliance model number, serial number and model description are located on the appliance data
plate on the end of the heater or inside the cooler in the vicinity of the electronic controls. These details
should also be in the warranty section of this booklet.
You will need this information, should your appliance require servicing, spare parts or just if you require
additional information about this product.
W
ARRANTY
Warranty service work must only be carried out by Climate Technologies service division or its authorised
service providers. See warranty section.
Comfort Control - PNE Page 5