KBC Networks WESII - Manual (Page 115)

WESII User Manual
Manual-WESII-Rev1403
Copyright © KBC Networks 2014
Page 114 of 140 www.kbcnetworks.com
11.2.3 System
The ‘System’ page allows certain configuration and upgrade changes to be performed to
the WESII system. KBC Networks recommends using the configuration backup to save
the settings of each unit once any custom configurations are complete.
11.2.3.1 System: FIRMWARE UPGRADE
To upgrade the WESII firmware, follow the procedures below:
1. Contact KBC Networks to get a firmware upgrade emailed to you.
2. Connect an Ethernet cable from the PIM attached to the WESII RF module to the
PC.
3. Access the WESII unit web browser interface and click on ‘SYSTEM’
4. Click on <Choose File>.
5. Search for the file in the location where it was saved (under step 1 above)
6. Select the file and open it. The file name should now be seen next to the Chose
File button.
7. Select <Upload>
8. Select <Yes> to continue.
9. When asked to Reboot select <Yes>.
10. When the Reboot is complete scroll down to the bottom of the page and select
<Reset to defaults…> and then select <Yes>