KBC Networks WESII User Manual
Page 62
WESII User Manual
Manual-WESII-Rev1403
Copyright © KBC Networks 2014
Page 61 of 140
www.kbcnetworks.com
9.4 Setting up a basic point-to-multipoint link -
United States & Canada
9.4.1 Host configuration for point-to-multipoint - United States &
Canada
Step 1:
Remove the WESII PoE point-to-multipoint Host or the WESII non-PoE
point-to-multipoint Host, Power Supply Unit (PSU) and Power Injector
Modules (PIM) (for non-PoE units only) from the box.
Step 2a:
For a WESII non-PoE unit:
Connect the first Ethernet straight through cable from the ‘IN’ on the PIM
to either a laptop or a PC LAN port.
Connect the second Ethernet straight through cable from ‘OUT’ on the
same PIM to the WESII Host LAN port.
Apply power to the PIM with the provided 24Vdc PSU and allow 60 seconds
for the unit to boot up.
Step 2b:
For a WESII PoE unit:
Connect an Ethernet cable from the PSE device (eg. Ethernet switch) to
the LAN port of the WESII unit.
Connect a second Ethernet cable from another port on the PSE to the
laptop or PC LAN port.
Apply power to the PSE device and allow 60 seconds for the unit to boot
up.