KBC Networks WESII - Manual (Page 99)

WESII User Manual
Manual-WESII-Rev1403
Copyright © KBC Networks 2014
Page 98 of 140 www.kbcnetworks.com
11.1.2 For a WESII PoE unit:
Connect an Ethernet cable from the PSE device (eg. Ethernet switch) to the LAN port of
the WESII unit.
Connect the second Ethernet straight through cable to either a laptop or a PC LAN port.
Apply power to the PSE device and allow 60 seconds for the unit to boot up.
See Section 7 for the WESII LED boot up process.
11.1.3 Accessing the GUI via a Web Browser
The computer used to access the WESII GUI must be set to a static IP address on the
same subnet as the WESII unit. The WESII default configuration is on the 192.168.1.x
subnet (refer to any provided documentation for the exact IP address for the individual
unit) therefore the computer must also be set to a 192.168.1.x IP address if the unit is
still on its factory set configurations.
Once the computer’s IP address is confirmed, open a web browser such as MS Internet
Explorer® or Mozilla Firefox®. Type in the Host/AP (192.168.1.200 default) or Client
(192.168.1.201 default) IP address in the address bar at the top of the web browser. If
the IP is correct and the link activity is established, the browser will prompt you to enter
the User Name and Password. The User Name and Password are ‘admin’ / ‘admin’ (case
sensitive).
User Name: admin
Password: admin