KBC Networks WESII User Manual
Page 121
WESII User Manual
Manual-WESII-Rev1403
Copyright © KBC Networks 2014
Page 120 of 140
www.kbcnetworks.com
11.2.4.1 System Topology Setup
Step 1:
All nodes within the network need to have a gateway address set on the
NETWORK - Basic Network page. This gateway must be a ping-able
network device that is connected to any one of the system node’s Ethernet
port. It does not have to be an actual gateway just a ping-able device – for
setting up this can be the PC you are connected to, you will also need to
turn off the firewall on the PC too. The system mapping uses ping to the
gateway as a mechanism for a low bandwidth means to confirm system
connectivity. If the system map were to be viewed from outside the
network, then this will be an actual gateway.
Set this to a ping-able
network device