Artesyn MVME55006E Single Board Computer Installation and Use (July 2014) - Manual (Page 104)

Connector Pin Assignments
MVME55006E Single Board Computer Installation and Use (6806800A37J) 104
5.2.11 VMEbus Connectors (P1 & P2) (SBC Mode)
The VME P1 and P2 connectors are 160-pin DINs. The P1 connector provides power and VME
signals for 24-bit address and 16-bit data. The pin assignments for the P1 connector are
specified by the VME64 Extension Standard (refer to
Appendix C, Related Documentation , for the
link to this specification).
Row B of the P2 connector provides power to the MVME5500 and to the upper eight VMEbus
address lines, and additional 16 VMEbus data lines. Please read the configuration notes below
as they apply to the P2 connector.
1. When J28 is configured for IPMC mode, –12V is supplied to P2 pin A30. If there is an
incompatible board plugged into this P2 slot, damage may occur.
2. When J32 is configured for IPMC mode, +12V is supplied to P2 pin C7. If there is an
incompatible board plugged into this P2 slot, damage may occur.
3. J102 – J110 should be configured for IPMC I/O to connect the IPMC extended SCSI signals
from J3 to the P2 connector.
The pin assignments for the P2 connector are as follows:
29 PMC2_44
(J24-44) PMC1_58 (J14-58) VD30 PMC1_57 (J14-57) PMC2_43 (J24-43)
30 GND PMC1_60 (J14-60) VD31 PMC1_59 (J14-59) PMC2_45 (J24-45)
31 PMC2_46
(J24-46) PMC1_62 (J14-62) GND PMC1_61 (J14-61) GND
32 GND PMC1_64 (J14-64) +5V PMC1_63 (J14-63) +5V
Table 5-16 VME Connector (P2) Pin Assignments (PMC Mode) (continued)
Pin ROW Z ROW A ROW B ROW C ROW D
Table 5-17 VME Connector (P2) Pinout with IPMC712
Pin Row Z Row A Row B Row C Row D
1 PMC2_2 DB0# +5V RD- (10/100) PMC2_1 (J24-1)
2 GND DB1# GND RD+ (10/100) PMC2_3 (J24-3)
3 PMC2_5 DB2# N/C TD- (10/100) PMC2_4 (J24-4)