Artesyn MVME55006E Single Board Computer Installation and Use (July 2014) - Manual (Page 110)

Connector Pin Assignments
MVME55006E Single Board Computer Installation and Use (6806800A37J) 110
5.3 Headers
This section discusses the various headers associated with the MVME5500.
5.3.1 Ethernet 2, PMC/SBC Mode, and P2 I/O Selection Headers (J6, J7,
J28, J32, J34, J97 – J110)
All of the headers described below are used in conjunction with each other to select various
modes of operation for 10/100BaseT Ethernet, PMC/SBC mode and P2 I/O mode.
105 MA4 MA3 106
107 MA2 MA1 108
109 +3.3V +3.3V 110
111 MA0 B2_CS# 112
113 B3_CS# GND 114
115 DQM5 DQM7 116
117 SDWE# SDRAS# 118
119 GND GND 120
121 SDCAS# +3.3V 122
123 +3.3V DQM6 124
125 DQM5 I2CSCL 126
127 I2CSDA A1_SPD (GND) 128
129 A0_SPD (NC) DQM4 130
131 DQM3 DQM2 132
133 GND CLK_MEZZ 134
135 GND +3.3V 136
137 DQM1 DQM0 138
139 GND GND 140
Table 5-19 Memory Expansion Connector (P4) Pin Assignments (continued)
Pin Signal Signal Pin