1 connection to peripherals, Figure 1-18, Installation into a typical vme chassis – Artesyn MVME55006E Single Board Computer Installation and Use (July 2014) User Manual
Page 44: Connection to peripherals, Wn in, And pl
Hardware Preparation and Installation
MVME55006E Single Board Computer Installation and Use (6806800A37J)
44
4. Ensure that the levers of the two injector/ejectors are in the outward position.
5. Slide the MVME5500 into the chassis until resistance is felt.
6. Simultaneously move the injector/ejector levers in an inward direction.
7. Verify that the MVME5500 is properly seated and secure it to the chassis using the
two screws located adjacent to the injector/ejector levers.
8. Connect the appropriate cables to the MVME5500.
1.10.1 Connection to Peripherals
When the MVME5500 is installed in a chassis, you are ready to connect peripherals and apply
power to the board.
shows the locations of the various connectors while
lists them
for you. Refer to
Chapter 5, Connector Pin Assignments
for the pin assignments of the
connectors listed below.
Figure 1-18 Installation into a Typical VME Chassis