Artesyn MVME55006E Single Board Computer Installation and Use (July 2014) - Manual (Page 41)

Hardware Preparation and Installation
MVME55006E Single Board Computer Installation and Use (6806800A37J) 41
5. Place the PMCspan on top of the MVME5500. Align the mounting holes in each
corner to the standoffs and align PMCspan connector P4 with MVME5100
connector J25.
6. Gently press the PMCspan and MVME5500 together and verify that P4 is fully
seated in J4.
7. Insert four short screws (Phillips type) through the holes at the corners of the
PMCspan and into the standoffs on the MVME5500. Tighten screws securely.
Figure 1-17 PMCspan Installation on a VME Module
2081 9708
PMCspan
MVME5500