Artesyn MVME55006E Single Board Computer Installation and Use (July 2014) - Manual (Page 112)

Connector Pin Assignments
MVME55006E Single Board Computer Installation and Use (6806800A37J) 112
For rear P2 Ethernet, install jumpers on all four headers (J34, J97, J98 and J99) when in
SBC/IPMC761 mode. No jumpers are installed for front-panel Ethernet.
5.3.1.2 PMC/SBC Mode Selection
Two 3-pin planar headers on the MVME5500 are for PMC/SBC mode selection. For PMC mode,
install jumpers across pins 1-2 on both headers. For SBC/IPMC761 mode, install jumpers across
pins 2-3 on both headers. For SBC/IPMC712 mode, install a jumper across pins 2-3 for J32 and
install a jumper across pins 1-2 for J28. Selection notes follow the table. The pin assignments
for these headers are as follows:
1. When J28 is configured for SBC/IPMC mode, –12V is supplied to P2 pin A30. If there is an
incompatible board plugged into this P2 slot, damage may occur.
2. When J32 is configured for SBC/IPMC mode, +12V is supplied to P2 pin C7. If there is an
incompatible board plugged into this P2 slot, damage may occur.
3. Install jumpers across pins 1-2 on both headers to select PMC mode. Install jumpers across
pins 2-3 on both headers to select SBC/IPMC761 mode. Install a jumper across pins 2-3 on
J32 and install a jumper across pins 1-2 on J28 to select SBC/IPMC712 mode.
1 PMC1_IO(3) 1 PMC1_IO (1)
2 P2_RX+ 2 P2_RX-
Table 5-21 Ethernet 2 Selection Headers (J34, J97, J98, J99) Pin Assignments (continued)
Pin Signal Pin Signal
Table 5-22 PMC/SBC Mode Selection Headers (J28, J32) Pin Assignments
J28 J32
Pin Signal Pin Signal
1 Fused –12.0V 1 Fused +12.0V
2 P2_PMC1_IO (60) 2 P2_PMC1_IO (13)
3 PMC1_IO(60) 3 PMC1_IO(13)