Artesyn MVME55006E Single Board Computer Installation and Use (July 2014) - Manual (Page 24)

Hardware Preparation and Installation
MVME55006E Single Board Computer Installation and Use (6806800A37J) 24
S3-2 Flash 0 Block Write Protect
Header OFF
[ON]
Disables Flash 0 J3 block writes
Enables Flash 0 J3 block writes
S3-4 Non-Standard Option
Header [OFF] For factory use only
S5-2 SROM Initialization Enable
Switch OFF
[ON] Enables SROM initialization
Disables SROM initialization
S4-1 PCI Bus 0.0 Speed Header [OFF]
ON
PMC board controls whether
the bus runs at 33 MHz or
66 MHz
Forces PCI bus 0.0 to remain at
33 MHz
J27 VME SCON Select Header No jumper installed
1-2
[2-3] Always SCON
No SCON
Auto-SCON
J28, J32 PMC/SBC Mode Selection
Headers
(set both jumpers)
Refer to
PMC/SBC Mode
Selection on page 27 for a
notice about configuring
for IPMC mode.
[1-2 on both]
2-3 on both
1-2 on J28
2-3 on J32
PMC mode
SBC/IPMC761 mode
SBC/IPMC712 mode
S4-2 PCI Bus 1.0 Speed Header [OFF]
ON
PMC board controls whether
the bus runs at 33 MHz or 66
MHz.
Forces PCI bus 1.0 to remain at
33 MHz.
S3-3 EEPROM Write Protect
Header OFF
[ON]
Disables EEPROM
programming
Enables EEPROM
programming
Table 1-2 MVME5500 Jumper Settings (continued)
Jumpers /
Switches
Function
Settings