Artesyn MVME55006E Single Board Computer Installation and Use (July 2014) - Manual (Page 21)

Hardware Preparation and Installation
MVME55006E Single Board Computer Installation and Use (6806800A37J) 21
1.4 Getting Started
This section provides an overview of the steps necessary to install and power up the
MVME5500 and a brief section on unpacking and ESD precautions.
1.5 Overview of Startup Procedures
The following table lists the things you will need to do before you can use this board and tells
where to find the information you need to perform each step. Be sure to read this entire
chapter, including all Caution and Warning notes, before you begin.
1.6 Unpacking Guidelines
Unpack the equipment from the shipping carton. Refer to the packing list and verify that all
items are present. Save the packing material for storing and reshipping of equipment.
Table 1-1 Startup Overview
What you need to do... Refer to...
Unpack the hardware. Unpacking Guidelines on page 21
Configure the hardware by setting
jumpers on the board. Configuring the Board on page 23
Install the MVME5500 board in a
chassis. Procedure on page 43
Connect any other equipment you will
be using Connection to Peripherals on page 44
Verify the hardware is installed. Completing the Installation on page 45